Black Forge Purple Filament Preface: I have to be honest up front, this filament took me through a lot of lessons to get to the point of the last few prints. To get to the point of writing this article, I had gone through 2 rolls of this filament. I got angry, I got […]
Cookiecad Blue Ombré Cookiecad is a unique brand, as not only are they and their site about their 3D printer filament, but also (as their name implies) cookie cutters. Check out their website on how to design, print, and even purchase cookie cutters. Their filament tends to be on the softer and pastel color side, […]
Dual Fan Shroud Upgrade for my Elegoo Neptune 2S (with RGB for flavor) One of the biggest downsides of the Elegoo Neptune 2S is the single cooling fan on the hot end. The Neptune 2 (and 2S) have a singe fan on the left side of the hot end, which works fine for some normal […]
Amolen Rainbow Silk PLA First let me start by saying this: This will not be much of a technical look and calibration of the Amolen Rainbow Silk PLA. Why? I was so excited to try out this filament, that I never did any tests. No, let it be known that I literally just shoved this […]
Elegoo Neptune 2S WiFi Install & Setup Setting up the Makerbase MKS Robin WiFi module on your Elegoo Neptune 2s (and other Elegoo models) is relatively simple, but will require disassembly of some of your 3D printer, and a little bit of technical knowledge. You will be getting into the innards of your beloved 3D […]
Duramic 3D “Neat” PLA 3D Printer Filament Like most new people to 3D printing, as you go along the huge sea of filaments to choose from, it cam become very overwhelming. Should I buy the “cheap” stuff and will if even work? This other filament is more expensive, does that mean it is better? […]
